For Models thru weight is approx. Thanks for all the info everyone. I have a SonicTronics glow system on my P for insurance and convenience. After reader your advice I will use a separate Mah pack to power the glow driver. Like Walt said, you don’t want to use your receiver battery to power your driver but if you got an old receiver pack and can solder you can make your own pack using the stuff that comes with the McDaniel driver.
|Date Added:||6 May 2009|
|File Size:||52.12 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
McDaniel RC on Board Glow Driver System 1 Cylinder MCD | eBay
The only downside is that wiring the system is a little involved. SonicTronics will sell you a pre-wired battery but they shipped the wiring harness with mcdaniel on board glow of my drivers needed to convert an old 4. Powered by X-Cart ecommerce solution. Standard 18″ 24″ 30″ 36″.
Molex Pins Installed Standard Do not install pins. Greg, Thanks for the offer, is the wiring harness just a Dean’s connector that I need to solder to my battery pack? Joe, You get deans connectors mcdaniel on board glow some heavy, 20 guage, wiring. I use mine on 3-cylinder engines and I mcdniel own mcdaniel on board glow glow drivers to be able to start the things without my driver although I once borrowed enough drivers from other guys at the field to be able to start my engine up once when tlow driver was dead.
Sonic Tronics Inc /
It has a remote L. Download and have a read. If you leave it on full time glkw may find that the battery will only last for a couple of flights. Send mcdaniel on board glow private message to WycheG. Am wondering if going up in voltage would help or would the plugs take it Don. The wires supplied that go from the controller to the plug are not that heavy and easy to route.
Molex Pins Installed standard Do Not install pins. Like Walt said, you don’t want to use your receiver battery to power your driver but if you got an old receiver pack and can solder you can make your own pack using the stuff that comes with the McDaniel driver. It takes a separate 4. McDaniel Glow Driver questions. Position 1 is full mcdaniel on board glow which is good for starting, position 2 is for flying- on boxrd idle only, and position mcdaniel on board glow is off. Joe, I didn’t know they cost more than other makes but I have 3 McDaniel’s glow drivers one for bench running and two mounted in aircraft.
This unit is set up for 2 – Single Cylinder Engines They deliver power for starting and maintaining idle during mcdaniel on board glow and power down flight maneuvers. The Driver electronics are packed in a plastic box for protection.
McDaniel RC Super Digital Onboard Glow Driver System MCD466
Powered by X-Cart ecommerce solution. You may not post new threads. Send a private message to Build-n-flyer-RCU. They go out of the way in the instructions to warn you not to use the standard wiring that comes on your receiver pack since the driver draws so mcdaniel on board glow more current than a receiver would.
A deans connector is supplied for the charging connection but if I had to do it over again I would use just a standard connector for this to make it easier to hook up a receiver battery charger.
The Driver electronics are packed in a plastic box for protection. mcdaniel on board glow
It has an external Deans Charge Jack for charging and external boosting. Glow drivers use a lot of power and you don’t want to take a chance of losing the radio due to a drained receiver battery.